Alu Mode; Alu-S Mode - Zipper Zi-Rwm99O Benutzerhandbuch

Check the result
•
Press key to return to dynamic mode
•
15.5.3

ALU mode

Same operation for ALU-1, ALU-2, ALU-3. Only the position to add counterweights is different
Input values a (rim distance), b (rim width) and d (rim diameter)
•
(see chapter "Dynamic mode")
Switch the machine on
•
• Press key till the required ALU-mode indicator lights up
• Put down the hood. Press key
• The unbalance values remain on unbalance position displays after finishing the measuring cycle
• Press key may check the real unbalance value under threshold
15.5.4

ALU-S mode

This mode is used for special rim.
If ALU-1 / ALU-2 or ALU-3 can not be used, you should choose ALU-S mode.
Switch the machine on
•
• Press key till the ALU-S mode indicator lights up
ZIPPER MASCHINEN GmbH
(at setting hood OFF) => measuring cycle starts.
Move the wheel slowly anticlockwise till all indicators of
•
outside unbalance position display lights up
• Add the counterweights on the outside 12 o'clock position
Move the wheel slowly anticlockwise till all indicators of inside
•
unbalance position display lights up
Add the counterweights on the inside 12 o'clock position
•
Check the result:
Put down the hood Press key
•
measuring cycle starts.
• If 0 0 is displayed, the result is OK
If the result is not satisfactory, repeat the balancing process
•
www.Zipper-Maschinen.at
OPERATION
(at setting hood OFF) =>
ZI-RWM99O
33