Step 8: Checking The Operation - Sony TDM-NC1 Bedienungsanleitung

STEP 8: Checking the
Operation
N
1
Make sure the display message of the
unit.
The message "Configuring" appears, then
"Loading" follows and then disappears. Go
to step 4.
If "SERVER?" appears, go to step 2.
Notes
• If "Check Net" appears, check the network
settings in STEP 7. Or, the wireless signal may
be weak or out of range, move the unit closer to
the wireless access point.
• If "No Server" appears, do the following;
– Make sure the Firewall setting are correct.
– Right click the M-crew Server task tray icon
in the computer's task tray, then select [Stop
Music Service], and right click the icon
again. Then, select [Start Music Service] to
restart the M-crew Server.
– Restart your computer.
– Execute "DataBaseClear.exe" to initialize
the database (usually located in C:\Program
Files\Mcrewserver).
– Input the wireless network key numbers/
characters again.
• If the "Configuring" or "Loading" messages do
not disappear after a few minutes, or other
messages mentioned above appear, see page 35.
2
Press ENTER.
3
4
Notes
• When playing the sample music, the unit display is
shown below.
ENTER
./>
+/–
* This icon appears when connecting the unit by
wireless connection.
• If no sound is heard, check if the connected AV
system's volume is set to zero, or the AV system's
function is set to other than DMPORT.
• If you have a problem, see "Troubleshooting"
(page 34).
Press . or > repeatedly until
"Mcrew Server v2 on XXXX (your
computer name)" appears, then press
ENTER.
Press N and check that music or
sample music is played.
*
GB
20