Technical Specifications; Product Description - Cangaroo Rm-T9150 Gebrauchsanweisung

16. Do not try to open or repair the appliance by yourself. In the case of damage contact the customer service
center of CANGAROO in your country.
17. WARNING: In order to avoid the risk of electric shock:
NEVER IMMERSE THE APPLIANCE IN WATER!
18. Do not leave and do not keep the product in a place, where it can fall or can be pushed into sink or bath.
19. Do not use the USB cable for other purposes.
20. Do not immerse the plug or the appliance into water or other fluid.
•WARNING: In order to reduce the risk of burnings, electric shock, fire and injuries:
•Do not put accessories, which are not approved by the manufacturer and do not make any improvements or
changes in the product as this will lead to its malfunction or damage.
• Do not use this product when there is damaged cord or plug, if it doesn't operate properly, if it was dropped
or damaged, or if it has been dropped into water. You should contact the sales agent, from which you have
bought the product or the importer, in order the appliance to be repaired.
•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Do not try to repair the product or the cable/ plug by yourself.
• Keep the cord away from heat sources or hot surfaces.
• Do not try to modify the product or to repair it by your self when there is damage. For advise contact an
authorized service center or the shop, from where you bought the warmer.
• Do not use spare parts, which are not the original ones, provided by the manufacturer or the importer.
1. Operating temperature: 10°C ~ 65°C; 2. Temperature setting: 38°C - 50°C; 3. Power supply: DC 5V/2A -
9V/2A; 4. Connection: USB-C (Type-C) cable.
The portable bottle warmer is a convenient and easy-to-use appliance designed to maintain the optimal
temperature of liquids such as milk or water. It works with a USB power supply, allowing it to be used at home, in
the car or on the go. Thanks to its insulating sleeve, the device provides effective heat retention while ensuring
safety in use.
PARTS - SEE FIGURE PD:
1 – Velcro fastening; 2 – Handle; 3 – Temperature control panel; 4 - USB-C (Type-C) cable.
 Do not connect the empty bottle to the power supply!
 Auxiliary heating can only be carried out when the liquid in the bottle is over 60 ml.
 Do not use the USB cable for other purposes. Use a charger with DC 5V/2A - 9V/2A.
Attention! Note that the speed at which the appliance heats the milk depends on: the bottle size; the
material used for the bottle; and the temperature of the milk (e.g. room temperature 20°C or after being taken
out from the fridge 5°C).
The final temperature of the milk depends on the size, material (plastic or glass), type and amount of liquid.
Recommendations:
- The temperature in the water will decrease with few degrees, when the powdered milk get poured into the
bottle with water.
- The temperature of the water can influence by the high or low initial temperature of the liquid in the baby
bottle.
 USE
1. Pour boiled water into the bottle, then tighten the Velcro strip tightly.
Caution! When using smaller baby bottles (e.g., 180 ml), ensure they are properly positioned. The bottle's neck
should always remain outside the heater to prevent improper heating and the risk of burns to the baby.
2. Connect the USB cable to the sleeve and the power source (charger, external battery, USB port in the
vehicle) (Fig. 2).
3. To turn on the device, press the power button (Fig. 3).

TECHNICAL SPECIFICATIONS

PRODUCT DESCRIPTION

APPLIANCE PARTS AND USE
5