Preparing For Use - Miele HS07 Gebrauchsanweisung

en

Preparing for use

Attach the suction tube (dia. 01)
 Fit the suction tube with the square
hole facing upwards into the body of
the vacuum cleaner and twist gently
until it clicks into place.
To detach the suction tube
 Press the release button (see detail)
and pull off the tube with a gentle
twist.
Connect the handle to the suction
tube (dia. 02)
 Fit the handle with the square hole fa-
cing upwards into the tube and twist
gently until it clicks into position.
 To detach the handle from the suction
tube, press the release button and
pull the handle out of the suction
tube, twisting it slightly as you do so.
The handle can also be fitted directly to
the body of the vacuum cleaner (dia.
03).
The vacuum cleaner is then easier to
use, e.g. when vacuuming mattresses,
upholstery etc.
Attach the standard floorhead / hard
floorbrush (dia. 04)
 Attach the floorhead / floorbrush to
the vacuum cleaner connection stub
and twist gently until it clicks into po-
sition.
 To detach the floorhead or floorbrush,
press the release button and pull the
vacuum cleaner away from the floor-
head twisting it slightly as you do so.
36
The suction tube can also be attached
to the vacuum cleaner connection stub
(dia. 05). This is useful for vacuuming
underneath low furniture, for example.
Using the SRD hard floorbrush
(depending on model)
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
This hard floorbrush is especially suit-
able for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
Winding up the mains cable (dia. 06)
When the vacuum cleaner is not in use
the cable can be wound around the two
cable hooks.
Secure the cable by clamping the plug
to the cable (see detail).
Using the accessories supplied
(dia. 07)
 Accessory clip

Crevice nozzle

Upholstery nozzle
Accessory clip (dia. 08)
(depending on model)
 If required, attach the accessory clip
to the suction tube.
 Push the accessory clip down over
the cable hook ring until it clicks into
position.
The accessory clip holds the accessor-
ies (dia. 09).