Herunterladen Inhalt Inhalt Diese Seite drucken

System Components; Installation; Installation On The Roof - Megasat Caravanman 65 Premium Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Caravanman 65 Premium:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Einführung

1.4 System components

Open box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down!. When you lay down
the antenne, pmake sure that the cable attached to the antenna not be below the base
plate to prevent damages.
Antenna unit
The 85 cm (or 65 cm) wide dish is screwed in a few steps to the
motor unit, thus forming the complete antenna unit. The mirror
is mounted only after the installation of the motor unit.
Control unit (IDU)
The control unit is used for satellite selection and control. It is
connected between the antenna and the set-top box and sup-
plied the antenna with electricity. After successful alignment,
the device switches off automatically.
Warning:
The Caravanman 85 Professional has an additional Auto Skew function that ad-
just the polarization angle of the LNB automatically, and a additional connecti-
on for a second set-top box.
04
ENGLISH

2. Installation

2.1 Installation on the roof

Basically, we recommend that you leave the installation to make by your dealer or workshop!
Warning:
Please also note that the antenna height of the vehicle will change accordingly!
Please strictly adhere to the various points in the installation instructions!
General Information:
Provide a suitable working environment, a garage/warehouse is better than open air.
The ambient temperature for installation is between +5° C and max. +25° C. Work not
directly in the sun. Comply with the safety regulations when handling with chemical
products. Provide the necessary hygiene.
Preparation:
1. Make sure that the roof of your vehicle is sufficiently stable. In case of insufficient or
doubtful roof stability is an approximately 2 mm thick plate with 100 x 100 cm is to be
attached to the outer roof skin. Ask to your vehicle manufacturer.
2. Make sure that all parts are present.
3. Place the antenna on the later assembly
area and align it so that the mirror and the
LNB unit pointing towards the rear of the
vehicle. Make sure that the slot is flat and
no roof structures in the way that can in-
terfere with satellite reception. Construc-
tions up to 20 cm in height do not matter,
higher ups should have a corresponding
distance to the antenna, so that no obst-
acle exists between the antenna and the
satellite. The least distance to an air condi-
tioner should be 30 cm.
4. Clean the mounting surface with a suita-
ble cleaner and a fleece cloth to remove
dirt and impurities. Then draw the anten-
na feet with a pen.
ENGLISH
05

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis