VEVOR GB-GO16A-R Montageanleitung Seite 27

BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution.
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up
liquid with 3 parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder, and connect the on/off valve to the burner to
ensure that the connection is secure, and then turn on the gas.
Brush the soapy solution onto the hose and all joints.If bubbles appear, this
indicates a leak which must be corrected before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to cure leakage but
consult your gas dealer.
Lighting Instructions for barbecue
1.Turn the control knobs clockwise to "OFF" position.
2. Connect the regulator to the gas cylinder. Turn the gas supply "ON" at the
regulator. Check for gas leakage between the bottle and the regulator with soapy
water.
3. Press the control knob and continue to press while turning counterclockwise to
the "HIGH" position (a click will be heard). If not, repeat the process.
4. If the burner is still not ignited after a new attempt, wait for 5 minutes and repeat
step 3.
5. Adjust the heat by turning the knob to the High/Low position.
6. If the burner does not light. Light the appliance with a match using the lighting
hole in the side of the appliance. Consult your gas dealer to rectify the ignition.
- 26 -