Making A Tmo Group Call; Receiving A Tmo Group Call; Receiving A Tmo Broadcast Call; Ptt Double Push - Motorola MTP850 S Bedienungsanleitung

Making a TMO Group Call

1. From the Home display and if this is the required group, press
and hold the PTT.
2. Wait for the talk permit tone and then speak into the microphone.
Release the PTT button to listen.
When you start a call, all members of the selected group who have
their units turned on, will receive the Group Call.
If you are in an on-going Group Call and wish to make a new call,
press
The No Group message is displayed when you are out of the
normal coverage area of your selected group. You must then select
a new group that is valid for your working location.

Receiving a TMO Group Call

Unless it is engaged in a call, your MTP850 will receive the Group
Call. To answer the call, press and hold PTT.
Your MTP850 shows the group name and the caller's private
number or alias if previously stored in your contact list.

Receiving a TMO Broadcast Call

The Broadcast Call (also called Site Wide Call) is a high-priority
Group Call from the console operator (or dispatcher) to all users.
The MTP850s are configured to monitor a Broadcast Call, but users
cannot talk back.
The Broadcast Call pre-empts an on-going Group Call that has the
same (or lower) call priority.

PTT Double Push

This feature, if enabled by your Service Provider, allows you to send
the tone when the radio is in idle or Group Call mode by pressing
PTT twice. After the D-PTT tone is played, the user can press and
hold the PTT once again to get the permission to talk.
To change the tone, press
Tone Style and choose Single, Double or Triple. Please go to
"Audio Signal Tones" on page 8 to view the specification of the
tones.
to ignore the current call. Start the new call
MENU
> Setup > Tones > D-PTT >
.
37