Kinderkraft RACOON Bedienungsanleitung Seite 17

•
All assembly parts and frame shall be well tightened during the assembly and
regularly checked and tightened if necessary.
•
Do not leave children alone so that they do not climb on furniture.
•
Maximal load of the bookcase - 28 kg.
•
The product is not a toy.
•
Assembly the product in accordance with the following instructions. Incorrect
assembly increases the risk of accidents and damage.
•
To protect the product against falling over it should be used with the attached
wall mounting device.
1. List of parts - 5
2. Assembly of the bookcase:
Tools: Philips and flat-blade screwdriver. Do the assembly on a soft floor that
will not damage the surface of the parts. The product shall be assembled by
two persons.
I. Start the assembly of the bookcase by placing the side wall of the bookcase
(A) and four beams (C) perpendicular to each other. Tighten the beams to
the wall with screws (1), considering the corresponding openings.
II. Lay two boards perpendicularly (E and H). The groove of the wider board shall be directed to
the floor. Pay attention to the openings. Then connect both boards with screws (5).
III. Attach the connectors (2) and the studs (4) to the structure from 2. step. Pay attention to the
openings. The connectors (2) shall be inserted in such a manner that the bushings in the
connectors are compatible with the openings on the side surfaces of the board. Gently but
stable fasten the studs (4) in the board. Attach the whole structure to the set from 1. step with
the screws (3). Lay the board (F) in such a way that you can see the groove. Insert the connectors
(2) in such a manner that the bushings in the connectors are compatible with the openings on
the side surfaces of the board.
Gently but stable fasten the studs (4) in the board. Attach the whole structure to the set from
1. step with the screws (3).
IV. Slide the material (D) onto the beams (C).
V. Slide the board (G) into the appropriate grooves.
VI. Attach the connectors (2) and the studs (4) to the structure from the steps above. Pay
attention to the openings. The connectors (2) shall be inserted in such a manner that the
bushings in the connectors are compatible with the openings on the side surfaces of the board.
Gently but stable fasten the studs (4) in the board. Fasten the side wall (B) to the structure with
screws (1,3). For safety, check all connections in the bookcase again and tighten the screws if
necessary.
VII. Lay all parts (I, J, K, L) of the boxes on the floor. Lay the parts (I and L) so that they look like
a box. Then put in the square bottoms (J and K) to stiffen the box.
VIII. With two screws (7) fasten the handles (6) to both side walls from the inside in such a way
that the oval opening of the handle adheres to the surface of the side wall (A, B). Pay attention
17