Cinq Shift R tour Bedienungsanleitung Seite 18

installation
Material Shift:R Tour
• 2 x shift cable index housing
with end caps on both sides
• 2 x wire end caps
• 2.0 Allen key
• 3.0 Allen key
• side cutter / cable cutter
• grease
1a Shift:R Tour Mount the levers on your handle bar in your ergonomically
preferred position. Fasten the hex screws with a maximum clamping torque
of 2.5 Nm. If you have to disassemble the lever, tighten the TX25 bolt with a
torque of 5 Nm (44 IN LB) and use intermediate bolt adhesive.
1b Shift:R Road Pull back the rubber hood to expose the 5 mm hex head
clamping nut – loosen and slide onto bar. Place the levers in an appropriate
position and tighten to 4­6 Nm (35­53 IN LB). Route the brake hose along
the handlebar. There should be no kinks or bends that collapse the housing.
You can adjust the reach of the blade by 2 mm Allen key to suit your
preference.
Material Shift:R Road
• 2.0 Allen key
• 5.0 Allen key
• 10 Torx
• side cutter / cable cutter
• grease
2.5 Nm
4-6 Nm