ZAMEL exta free RZB-04 Bedienungsanleitung Seite 8

OPERATION, MOUNTING ROP-02
Disconnect power supply by the phase fuse, the circuit-breaker or the switch-discon-
nector combined to the proper circuit.
Check if there is no voltage on connection cables by means of a special measure
equipment.
Connect the cables with the terminals in accordance with the installing diagram.
Install ROP-02 device in installation cable box.
Switch on the power supply from the mains.
The device can operate in five modes:
MONOSTABLE the relay operates only while pressing transmitter's push-button.
BISTABLE (one push-button) the device changes relay status cyclically always after
pressing the same push-button.
SWITCH ON the device switches on after pressing the push-button.
SWITCH OFF the device switches off after pressing the push-button.
TIME the device switches off according to the adjusted time (tp), but it may be switched
off before adjusted time finishes. Default settings - 15 seconds.
CAUTION! Adjusted time will not be deleted.
RADIO TRANSMITTERS POGRAMMING - CHANNEL 1
MONOSTABLE mode:
Press transmitter's push-button for a longer time.
02 device for a longer time until LED red diode switches on (constant signal). Next re-
lease PROG push-button.
on (first signal pulsates, next the signal is constant).
push-button and release it. LED red diode switches on (the signal pulsates) and next
the signal switches off - THE TRANSMITTER IS ADDED.
BISTABLE mode:
Press PROG push-button of ROP-02 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
ter's push-button for a longer time. LED red diode switches on (first signal pulsates, next
the signal is constant).
(the signal pulsates), next the LED red diode switches off - it means the TRANSMITTER
IS ADDED.
SWITCH ON/SWITCH OFF mode (two push-buttons):
Press PROG push-button of ROP-02 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
transmitter's pushbutton. LED red diode switches on (first signal pulsates, next the sig-
nal is constant).
diode switches on (the signal pulsates) and next it switches off - THE TRANSMITTER
IS ADDED.
TIME MODE (one push-button):
Press PROG push-button of ROP-02 device for a longer time till LED red diode switches
on (constant signal). Next release PROG push-button.
pushbutton. LED red diode switches on (the signal pulsates, next the signal is constant).
Press and release the same transmitter's push-button. LED red diode switches on (the
signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
An exemplary programming procedure with the use of P-257/2 remote controller.
The procedure for the rest of radio EXTA FREE transmitters is analogous.
CAUTION: Every transmitter can cooperate with ROP-02 in a different mode,
depending on how they were added to the device. One transmitter can be added
during one programming cycle. Full memory is signalled with pulsating LED red
diode.
Release transmitter's push-button. LED red diode switches
Release transmitter's push-button. LED red diode switches on
Press and release the second transmitter's push-button. LED red
Press PROG push-button of ROP-
Press the same transmitter's
Press the transmit-
Press and release
Press and release transmitter's