Battery Change - Zamel Exta Free Rzb-04 Bedienungsanleitung

FUNCTIONING, MOUNTING RNK-04
By pressing the button, the transmitter sends a signal with 868 MHz frequency which
controls EXTA FREE receivers. Device programming procedure (adding a transmit-
ter to a receiver's memory) is described in particular EXTA FREE manual instruc-
tions. The device range (up to 250 m depending on a receiver) can be increased by
means of a retransmitter or few RTN-01 retransmitters. The device can be mounted in
any place by means of double-sided adhesive tape or wall plugs 5 x (3 x 30) mm.
Mounting by means of wall plugs:
Remove push-buttons - to do it press a push-button on one side, and on the other
side put a screwdriver into a slot and lift it up.
Find a place on the wall to mount the transmitter, make two holes corresponding
mounting holes from the transmitter's base.
Set wall plugs in the holes.
Fix the base by tightening the screws into wall plugs.
Place the push-buttons back.

BATTERY CHANGE

Battery discharge status is signalled by several LED red diode flashes during
transmission time.
Remove push-buttons (Fig. 1).
By means of a screwdriver lever up the printedcircuit board releasing the bottom
latch (Fig. 2) and remove it from the base.
Remove the battery from the latch. (Fig. 3)
Mount a new battery. Watch battery polarisation marked on the latch. Wrong
battery mounting may cause device damage.
Put the removed printed-circuit board back in the base.
Place the push-buttons back.
CAUTION: While changing the battery, it is suggested to press any of the buttons
for about 5 seconds before putting it into a latch. Next press transmission button
several times to check its operation. If the transmitter does not work properly
repeat the battery change procedure.
1
CAUTION! SUBSTITUTING THE BATTERY WITH ANY BATTERY OF INCORRECT TYPE
MAY CAUSE AN EXPLOSIVE HAZARD. DISPOSE OF USED BATTERIES AS STATED IN THE
2
MANUAL.
3