Regulatory Information; Regulations Statements - A-Rival Nav-Pnf Hardware-Benutzerhandbuch

Regulatory information
NOTE: Marking labels located on the exterior of your device indicate the
regulations that your model complies with. Please check the marking labels on
your device and refer to the corresponding statements in this chapter.
Some notices apply to specific models only.
6.1 Regulations Statements
Class B Regulations
USA Federal Communications Commission Radio Frequency Interference
Statement
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential in
stallation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
guarantee that interference will not occur in a particular
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
. Reorient or relocate the receiving antenna.
Increase the separation between the equipment
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
Please note:
The use of a non-shielded interface cable with this equipment is prohibited.
Canada
Canadian Department Of Communications
However, there is no
installation.
and receiver.
20
Requlatory information
Radio Interference Regulations Class B Compliance Notice
This Class B digital apparatus meets all requirements of the Canada
Interference-Causing
Cet appareilnumériquede ClasseB respectetoutes lesexigencesduRéglement
Canadien sur le matériel
European Notice
products with the CE marking comply with Radio & Telecommunication
TerminalEquipmentDirective(R&TTE)(1999/5/EEC),the Electromagnetic
Compatibility Directive (89/336/EEC) and the Low Voltage Directive
(73/23/EEC) as amended by Directive 93/68/ECC - issued by the
Commission of the European Community.
Compliance with these directives implies conformity to the following European
Standards:
If this
EN301489-1:Electroniccompatibilityand Radio spectrumMatters(ERM),
ElectroMagnetic Compatibility (EMC) standard for radio equipment
and services; Part 1: Common technical requirements
EN301489-3:
Electronic compatibility and Radio spectrum Matters (ERM),
ElectroMagnetic Compatibility (EMC) standard for radio equipment
and services; Part 3: Specific conditions for Short-Range Devices
(SRD) operating on frequencies between 9 kHz and 40 Ghz
En55022: Radio disturbance
EN55024: Immunity characteristics
EN6100-3-2: Limits for harmonic
equipment regulations.
brouileur.
characteristics
current emissions
21