Reset; Gps Receiver; Trouble Shooting; Your System - A-Rival Nav-Pnf Hardware-Benutzerhandbuch

Devices settinqs
2. Tap the button to restore to factory default setting, or tap the
0K
button to quit modification .
4.1 GPS Receiver
NOTE: This page is for information only. You can view the number of satellite
signals the unit is receiving and also the strength of these signals.
1. Tap "GPS Receiver" button on the Device Settings menu.
2. The GPS Receiver Function menu appears as shown below.
OOO.
This page gives your current position in degrees longitude and latitude, your
current speed and the status of your position, i.e. Fixed 3D or Fixed Invalid etc.
The compass circle shows the satellites that the unit is receiving and the bar
chart below shows the strength of the signal from each of these satellites.
16
Troubleshooting and maintenance
This chapter gives solutions to common problems you may encounter. It also
provides guidelines on taking care of your device.
NOTE: if you encounter a problem you can not solve, contact an authorized
service center for assistance.
5.1 Resetting Your System
Occasionally, y ou may needto reset your device.For example,you should reset
your system when it stops responding; or appears to be "frozen" or " locked up" .
Insert a small rod, such as a straightened paperclip, into the reset button on the
bottom of your device. This is called a
appear after a soft reset.
If your device still does not respond after a soft reset, you can use the
following steps to perform a "hard reset."
1. Disconnectall cables,includingtheAC adapter,from your device.
2. Press the ON/OFF button to the OFF position.
3. Wait for I minute and then press the button back to the ON position.
ON/OFF
4. Your device turns on.
5.2 Troubleshooting
Power Problems
Power does not turn on when using battery power
The remaining battery power may be too low to run your device. Connect the AC
adapter to your device and to AC power. Then, turn on your device.
"soft

reset."

The Main Menu should
RESET
17