Using The Tmc; Using The Car Holder; Connecting The Car Charger; Performing The Initial Start Up - A-Rival Nav-Pnf Hardware-Benutzerhandbuch

Gettinq Started
1.3

Using the TMC

Antenna
Build-in TMC
connector
(see the picture) - connect TMC Antenna to the TMC Jack of your device.
1.4

Using the Car Holder

CAUTION:
Select an appropriate location for the car holder. Never place the holder where
the driver's field of vision is blocked.
. If the car's windshield is tinted with a reflective coating, an external antenna
(optional) may be needed to route the antenna to the top of the car through a
window. When closing the car window,
cable.
(Cars with an anti-jam window design may automatically leave adequate space
as needed.)
The car holder consists of a bracket
use the car holder to fix your device in a
vehicle. Make sure that the GPS antenna
clear view of the sky.
(See the document supplied with the car holder
for the installation instruction.)
For initial positioning, remain at the same spot with a clear view of the sky. The
GPS may take a few minutes to find its current location initially.
NOTE: Depending upon the specific model purchased, the car holder supplied
with your device may not look exactly the same as the picture shown.
1.5

Connecting the Car Charger

The car charger supplies power to your device when you are using the device
in a car.
41b,
be careful not to pinch the antenna
and a stand.
has a
8
Gettinq Started
CAUTION: To protect your device against sudden surges in current, connect the
car charger only after the car engine has been started.
1. Connect one end of the car charger to the power connector of your device.
2. Connect the other end to the cigarette lighter in the car to power and
charge your device. The indicator on the car charger lights in green to indicate
that power is being supplied to your device.
Operatinq Basics

2.1 Performing the Initial Start Up

1. press the ON/OFF button for several seconds.
ON/OFF
2. Your device will automatically turn on. Connect the car charger as described
in the next section.
3. The Opening screen appears.
a»rlVRL
4. The Main Menu appears as shown below. You can now use your device.
5. Fully charge the battery before using your device for the first time.
9