Overview Of The Components; Unpack Device; Intended Use - Clatronic MZ 3579 Bedienungsanleitung, Garantie

WARNING: Risk of injury!
• Appliances can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of
the appliance in a safe way and if they understand the hazards
involved.
WARNING:
• The blades of the knife are very sharp!
• Take care when handling the knife!
• There is a risk of injury especially when attaching/removing the
knife into or from the bowl and during cleaning!
CAUTION:
The motor assembly must not be immersed in water for cleaning.
Follow the instructions provided in the chapter "Cleaning".

Overview of the Components

1 Switch
2 Motor unit
3 Protective cover with seal
4 Knife
5 Bowl

Intended Use

This appliance is intended for processing foodstuffs that can be
shredded.
It is only designed for this use and should only be used for this
intended purpose.
It is not suitable for stirring or mixing liquids.
Do not operate the appliance when empty.
Only use this device as instructed in this user manual. Do not
use this device commercially.
No other use is intended and can cause damage or personal
injuries.
The manufacturer does not assume any liability for damages
resulting from improper use.
26

Unpack Device

• Take the device out of its packaging.
• Remove all packaging materials, such as foils, filling mate-
rials, cable ties and cartons.
• Check that all accessories are included in the box.
NOTE:
Clean manufacturing residues and dust from the device as
described under "Cleaning".
Preparations and general information
• Prepare the dish. Refer to the table below.
• Place the bowl onto a flat surface.
Assembling the appliance
1. Place the knife onto the shaft on the bottom of the bowl.
NOTE:
• The shaft on the bottom of the bowl drives the knife.
• Always fit the knife first. Only then fill in the food.
• The protective cover has a seal at the bottom.
• First check to make sure that the seal is positioned
correctly.