Product Description; Components And Functional Elements; Standard Delivery - Renfert Basic Master Kurzanleitung

Safe condition of the unit
Faulty or broken components, or those that are not sealed as required, may cause injuries.
en
⇒ Check the power cord, housing, and other components such as connection cables, tubes, and the key
pad for damage, for example such as kinks, cracks, porosity, and signs of aging.
⇒ Defective equipment must be taken out of service immediately. Disconnect the power plug. Send
the unit in for repair or dispose of it safely. Until this happens, secure the unit to prevent it from being
switched on again so that it is not used inadvertently.
⇒ Do not expose the unit to mechanical impact. Do not drop it.
Risks as a result of modifications and repairs
Incorrect modifications and repairs to the unit may cause accidents, fire, and electric shock.
⇒ Only have the unit repaired by qualified specialist dealers or return it.
Risk as a result of electric shock and fire
Risk of electric shock and of fire as a result of excessive operating voltage or if there is no protec-
tive conductor.
⇒ Ensure that the power plug is easily accessible.
⇒ Only operate the unit using a power cord equipped with a plug appropriate to the local power supply.
Only allow qualified electricians to modify power cords.
⇒ Only start the unit if the information on the nameplate matches the power supply.
⇒ Only connect the unit to electrical sockets that are connected to the protective conductor system.
Risk of injury to the eyes or skin
Injury may occur to the eyes or skin as a result of high pressure or of components fracturing that
are subject to high pressure.
⇒ Always wear appropriate protective goggles when carrying out work on the unit.
⇒ Never direct the blasting material towards the eyes or unprotected areas of skin.
⇒ Never perform sandblasting with the viewing panel open.
Risk to health as a result of dust
Dust emissions may result in damage to health.
⇒ Operate the unit with a suitable extraction unit. The extraction unit must be adapted to the dust that
occurs.

Product description

Components and functional elements

See Fig. 1 (on inside cover)
1 Selector switch
2 Pressure regulator
3 Appliance socket
4
ON / OFF switch
5 Tank lid
6 Pressure gauge
7 Protection screen
8 Hand piece
9
Hand sleeves
10 Base grid
11 Air connection
12 Water trap

Standard Delivery

1 Basic master
1 Foot switch
1 Connection set
1 Power cord
1 Quick Start Guide
13 Water trap valve
14 Foot switch connection (A)
15 Foot switch connection (B)
16 Mixing chamber
17 Filter cartridge
18 Suction tube
19 Sandblasting tank
20 Foot switch
21 Compressed air tube
22 Power cord
- 2 -