Sygonix 1518459 Bedienungsanleitung Seite 6

The mini smoke detector battery is dead
The mini smoke detector emits a short beep every 48 seconds (for at least 30 days) when the
battery is flat.
If this is the case, replace the mini smoke detector immediately with a new one.
The mini smoke detector battery cannot be replaced.
Establishing an escape plan and practising for an emergency
• Create a plan of your apartment or your house that shows all the doors and windows, and
allocate two escape routes for each room, if feasible. A rope ladder may be necessary for
windows on the second-floor.
• Keep the escape routes clear.
• Call a family meeting in order to discuss the escape plan and explain to each person what to
do in case of fire/smoke.
• Arrange for a meeting place outside of your home.
• Familiarise everyone with the alarm of the mini smoke detector; everyone must be aware that
when this sound is heard, everyone must leave the house immediately.
• Practice a smoke/fire drill at least every 6 months. Exercises will help you to put your evacu-
ation plan to the test before an actual emergency situation may arise. It may happen that you
cannot reach your children in a case of fire. It is important that they know too, what to do and
how to behave.
What to do in case of an alarm?
• If the mini smoke detector detects smoke, it will emit a loud alarm tone. The alarm stops when
the air is devoid of smoke.
• In case of an alarm, leave the home or the house immediately following the escape plan you
have created. Every second counts; do not waste time by getting dressed or trying to take
your valuables with you.
If you are not sure what has triggered the alarm (and it is not clear, if this is a false
alarm), regard the alarm as "emergency".
• Do not open any door without first touching the surface. If the door is hot, or if you see smoke
coming from under the door, do not open the door! Use the alternative escape route instead.
• If the surface of the door is cool, press your shoulder against it, open the door slightly and be
ready to slam it back again, if heat and smoke penetrate from the room behind it.
• If the air is filled with smoke, stay close to the floor. Breathe through a cloth (if possible)
moistened with water.
• Once you have left the apartment or the house, go to the agreed meeting place and make
sure everyone is there.
• Call the fire department from the house of your neighbour; do not call from your own!
• Do not go back into the apartment or the house until the fire brigade consents.
• If running outside is not an option, look for a safe place in the room. Close the door. Try to
attract attention, at the window for example. If possible, seal the door using wet towels, cloth-
ing, etc., to prevent or at least stop smoke from entering.
After a real fire with smoke development, the mini smoke detector must be replaced
with a new one for safety reasons.
Maintenance and cleaning
The product is maintenance-free for you. The battery cannot be replaced.
Clean the product with a soft, clean, dry cloth.
Dust on the mini smoke detector can be easily removed with a soft, clean, long-haired brush
or a vacuum cleaner; this should be done in rooms with a high dust load (e.g., in a bedroom)
at least once a year.
Do not use aggressive cleaning agents or solvents; these will damage the housing or may
impair functioning.
Disposal
Electronic devices are recyclable material and do not belong in the household
waste. Dispose of an unserviceable product in accordance with the relevant statu-
tory regulations.
Technical data
Operating voltage .............................. 3 V/DC by a permanently installed, non-replaceable
lithium battery
Battery life .........................................approx. 10 years
Alarm volume ....................................>=85 dB/3 m
Ambient conditions ............................ Temperature 0 °C to +40 °C, air humidity 10% to 90%
relative, non-condensing
Dimensions (Ø x H) ...........................approx. 40 x 43 mm (without mounting plate)
Weight ...............................................50 g
Manufacturer's service address
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2017 by Conrad Electronic SE. 39613R1 1518459_V1_0617_02_VTP_m_en