Hama RC 660 Bedienungsanleitung Seite 9

Alarm mode exit/snooze function
• If the alarm is triggered, the alarm symbol
will sound.
• Press any button (except the SNOOZE/LIGHT button (7)) to stop the alarm.
• Otherwise, it will stop automatically after 2 minutes.
Note – Snooze function
While the alarm signal is sounding, press the SNOOZE/LIGHT button (7) to activate
the snooze function. The alarm symbol
alarm signal will be stopped for 5 minutes, after which it will sound again.
5.5. Backlight
• If you press the SNOOZE/ LIGHT button (7), the display will light up for approx.
10 seconds.
• The alarm clock is equipped with a twilight sensor (7) that automatically switches on
the backlight of the display (10) to a dimmed setting as soon as it gets dark.
• During the day or if there is enough light, the twilight sensor (7) automatically
switches off the dimmed backlight on the display.
• Move the SENSOR OFF/ ON slide switch (11) to the SENSOR ON or SENSOR OFF
position to activate or deactivate the twilight sensor (7).
Note – Backlight
• We recommend deactivating the twilight sensor while the clock is not in use,
while it is packed during travel, etc.
• Continuous use of the twilight sensor will drain the battery.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive
cleaning agents. Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.
8
/ will begin to flash and an alarm
/ and will begin to flash. The