Hama RC 660 Bedienungsanleitung Seite 6

5.1. Automatic date/time setting using the DCF signal
• Once you have inserted the batteries, the display is switched on, an acoustic signal
sounds and the alarm clock automatically starts searching for a DCF radio signal.
During the search, the radio icon /
minutes.
• When the wireless signal is received, the date and time are automatically set.
Display flashing
Display steady (not flashing)
Not displayed
• Press and hold the MIN/ DATE button (10) for approx. 3 seconds to start a manual
search for the DCF radio signal.
Note – Time settings
• If, during initial setup of the device, no DCF radio signal is received within the
first few minutes, the search is aborted. The radio icon will go out.
• If there are reception problems, we recommend leaving the clock to sit overnight,
since interference is generally less at night.
• In the meantime, you can start a manual search for the DCF radio signal at
another location or you can manually set the time and date.
• The clock automatically continues to search for the DCF signal every hour. If the
signal is received successfully, the manually set time and date are overwritten.
Display
/
will flash. This process can take 3 to 5
Searching for the DCF signal
Successful – signal is being received
Inactive – no signal reception
Active
5