Hama TS33C Bedienungsanleitung Seite 8

• If the device does not connect automatically, the manual search
program on the base station must be started.
Note
• Initial setup takes approx. 2 minutes.
• During the connection attempt, the measuring station radio
symbol (1) will flash.
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
• The measured value is automatically updated by the base device
about every 45 seconds.
• If the temperature is outside of the measuring range, LL.L (lower
than minimum temperature) or HH.H (higher than maximum
temperature) will appear on the temperature display.
6.3. Selecting the channel/Other measuring stations
Note
• You can connect up to three different measuring stations to the
outdoor sensor. Ensure that the base and measuring stations
are set to the same channel. Visit www.hama.com for suitable
measuring stations.
• The transmission channel on the supplied measuring station can
be changed/set (CH1, CH2, CH3).
7