Blade Maintenance - Bosch Rotak 37 LI Bedienungsanleitung

During the charging procedure, the 3 green bat-
tery LEDs light up one after the other and briefly
go out. The battery is fully charged when the
3 green LEDs light up continuously. Approx.
5 minutes after the battery has been fully
charged, the 3 green LEDs go out again.
Temperature Control Indicator (see main figure)
The red LED 15 signals that the battery or the
electronics of the product are not within the opti-
mum temperature range. The product will not op-
erate at full capacity.
Temperature Control of the Battery
The red LED 15 flashes when the battery is not
within the optimum temperature range (–10 to
+60 °C) and button 13 or the On/Off switch 1 is
pressed.
The battery switches off at a temperature above
70 °C until the optimum temperature range is
reached again.
Temperature Control of the product Electron-
ics
The red LED 15 lights up continuously when
the temperature of the product electronics are
above 75 °C and the On/Off switch 1 is pressed.
At a temperature above 90 °C, the electronics
switch off the product until the temperature is
within the allowable operating temperature range
again
Area of Cut (Battery Duration)
The area of cut (battery duration) depends on lawn
conditions, grass density, mositure content, grass
length and height of cut.
Switching the product on and off frequently during
cutting will also reduce the area of cut (battery dura-
tion).
To improve the area of cut (battery duration) it is rec-
ommended to cut more frequently, raise the cutting
height and walk at a normal pace.
The Example below shows impact of conditions
against run time, for one battery:
8cm
4cm
15cm
4cm
23 • F016 L70 447 • TMS • 07.12.06
Light cutting (dry
grass)
2
Rotak 37 LI 150 m
2
Rotak 43 LI: 175 m
Medium cutting
(dense grass)
2
Rotak 37 LI: 100 m
2
Rotak 43 LI: 125 m
English - 7
To increase the run time an additional battery can be
purchased from an authorised customer service
agent for Bosch garden products.
Maintenance
Switch off, remove isolator key, battery
and grassbox before adjusting or clean-
ing.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged blade, loose fixings, and
worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (TYP) from
the nameplate of the machine!

Blade Maintenance

Switch off, remove isolator key, battery
and grassbox before adjusting or clean-
ing.
Turn the machine on its right side and inspect the
blade; if blunt or damaged, replace.
Use the following procedure to remove and replace
the blade.
Hold the blade 30 using gardening gloves (not pro-
vided) use a spanner (not provided) to remove the
blade bolt 29, blade washer 28 and blade. Fit the
blade, blade washer and the blade bolt. Ensure that
the blade is the correct way up (so that this
bol can be seen located as in figure I) and tighten the
bolt firmly.
In the event of a blade becoming difficult to remove
or fit, insert a screwdriver into hole 26 to lock the
drive. Ensure the screwdriver is removed before at-
tempting to turn the machine on.
Do not lubricate blade or blade bolt during
refitting.
sym-