Bosch Rotak 37 LI Bedienungsanleitung Seite 21

Battery Charged
Continuous lighting of the green
charge control LED 19 signals that
the battery is fully charged.
Additionally, a signal tone sounds for approx.
2 seconds, which acoustically indicates that the
battery is fully charged.
Afterwards the battery can be removed for imme-
diate use.
With no battery inserted, continuous lighting of
the green charge control LED 19 indicates that
the mains plug is plugged into the socket and that
the battery charger is ready for operation.
Battery Temperature below 0 °C and above 45 °C
Continuous lighting of the red
LED 18 indicates that the battery
temperature is not within the rapid-
charging temperature range of
0 °C – 45 °C. As soon as the allowable tempera-
ture range is reached, the battery charger auto-
matically switches to rapid charging.
When the battery is not within the allowable tem-
perature range, the red battery LED lights up
when inserting the battery into the battery
charger.
No Charging Procedure Possible due to Defec-
tive Battery
If a different malfunction of the
charging procedure is present, this
will be indicated through flashing
of the red charge control LED 18.
The charging procedure can not be started and
the battery cannot be charged. (see fault finding
for advice).
Charging Advice
With continuous or several repetitive charging
cycles without interruption, the charger can
warm up. This is not meaningful and does not
indicate a technical defect of the unit.
A significantly reduced working period after
charging indicates that the battery must be re-
placed.
Battery Cooling (Active Air Cooling)
The fan control integrated in the battery charger
controls the temperature of the inserted battery.
When the battery temperature is above 30 °C, a
fan cools down the battery to the optimal charg-
ing temperature. The switched-on fan produces a
fan noise.
21 • F016 L70 447 • TMS • 07.12.06
The battery temperature is within the optimal
charging temperature range when the fan is not
running, or the fan may possibly be defective. In
this case, the charging time of the battery ex-
tends.
Assembly
Do not connect the battery and/or the iso-
lator key before product is completely as-
sembled.
Handle assembly
A
Insert the handle bottom 6 into the holes provided
and
secure with the screws.
Note: The handle top 3 is height adjustable. Fix han-
dles in desired position I or II.
Attach the handle top 3 with the bolts and wing
nuts 22 to the handle bottom 6.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle.
Fitting/Removing Battery
Fitting
B
Lift the battery cover latch 23.
Lift up battery cover 7.
Fit battery 8, when correctly fitted a „click" will be
heard.
Fit the isolator key 24 as shown.
If the mower is not going to be used immediately
fit isolator key 24 as shown in the storage position.
Close battery cover 7.
Removing Battery
Lift the battery cover latch 23 and lift up battery
cover 7.
Remove isolator key 24, refit in storage position
Lift the battery cover latch 23.
Remove the battery 8.
Snap together the grassbox
Rotak 37 LI:
C
Snap the grassbox top on the grassbox bottom by
pushing all the "snap fits" together around the edges
starting at rear and working towards the front.
Rotak 43 LI:
D
Snap the grassbox bottom halves together by
pushing all the "snap fits" together around the edges
starting at rear and working towards the front.
Snap together both top and bottom half of the
grassbox.
Ensure the cables are not trapped when folding/un-
folding top handles. Do not drop the handles.
English - 5