Inserting The Battery; Control Panel; Operating Mode - SOLIS TRIPLE FAN PLUS Bedienungsanleitung

OPERATING INSTRUCTIONS

Inserting the battery

The remote control unit is fitted with a button cell battery type CR2032 (3 volt). Press the battery firmly
into the remote control unit, making sure that the polarity is correct. If you are not going to use the fan
for a long time, remove the battery from the remote control unit.

Control panel

Thanks to modern touch-screen technology, all the unit's functions can be accessed by simply touching
the symbols on the display lightly.
On/Speed
ON/SPEED: When the unit is first connected to the mains supply, it will be in Standby mode.
The display will not show anything at all. Touch
The other buttons/functions will then be displayed.
1. The standard settings after the fan is first switched on are:
a) Speed: Slow
b) Mode: Normal
c) Speed: Off
d) Timer: Off
e) Operating status of the three fan blades: all active
2. If the fan has already been in use, the previous settings will have been saved – with the exception
of the timer and sleep mode functions.
3. Press the
The speed sequence is: Low  Medium  High  Low, etc.
4. Once the unit has been switched on, the
when this light will also go out.

Operating mode

MODE: Touch the
Normal  Natural  Sleep  Normal, etc
1. Normal operating mode: The motor turns at the preset speed and the symbols for
do not light up.
2. Natural operating mode: The
motor alternates between the high – medium – low areas and repeats this sequence automatically.
16
970-89_TripleFanPlus-Betriebsanleitung_ger-fra-eng-ned.indd 16
button repeatedly during operation to set the speed.
symbol will stay on until the fan is switched off,
button during normal operation to set the ventilation mode as follows:
symbol lights up and the
to switch the unit on first.
display stays off. The
and
30.10.14 11:37