Preparing The Remote Control - SOLIS ECO SILENT 7584 Bedienungsanleitung

PR E P A RI N G T H E R E M O T E C ONT ROL
s
F OR U SE
GB
:
• Once you have inserted three AAA batteries (not included) into the battery
compartment on the back of the remote control, the remote control can be
connected to the pedestal fan and activated. After that, the remote control can
be attached to the round surface on the front of the safety grid.
Caution: The remote control is held by magnets on the round surface in the
centre of the safety grid. This mechanism requires batteries to be inserted.
• Open the battery compartment on the back of the remote control and insert the
three AAA batteries. Please mind the stated polarities.
CON NE C TIN G R ES P. ACTIVA TING TH E REMOTE CONTROL
1. Connect the power plug to a suitable power outlet and switch the appliance on
with the On/Off button on the control panel on the fan head.
2. Touch any button on the remote control to activate the remote control.
3. Then, touch the program button
onds. "00" flashes on the display, the four LEDs on the motor casing flash.
4. Touch any button on the motor casing within the next 5 seconds. The green
LEDs go out.
5. The room temperature is displayed in the LED display of the remote control. If
no other button is touched within 5 seconds, the display switches off.
6. After these activation and connection procedures, you can operate the appliance
with the remote control.
76
remote control
on the remote control for approx. 3 sec-
Note: If no connection could be made, "88" lights up in the display and the
display goes out after 5 seconds if no other button is touched. If that is the case,
we recommend repeating steps 2 to 5.
In general:
• You have to connect the remote control to the appliance, thus activating it,
before you can control the appliance with the remote control.
• If you touch a button on the remote control while the fan is running, you can
read successively the ventilation speed, the room temperature, the oscillation
angle and – if set – the timer symbol from the display for 5 seconds. There are
symbols displayed to the left of the number, indicating the set programs and
issuing a warning if the batteries are low. To the right of the number you can
see the symbols for the timer setting resp. the oscillation angle. If no button is
touched for 5 seconds, all prompts as well as the display on the remote control
go out to save the batteries.
•
The function buttons on the remote control offer further setting options in
addition to the buttons on the motor casing of the appliance. This allows you
to set the ventilation program, choose among 4 different oscillation angles and
activating the timer.
• When not using the remote control for extended periods of time, please remove
the batteries and store them away. This increases the lifespan of the batteries.
• Please make sure that the area between the remote control and the receiver is
unobstructed.
• Please keep the remote control safe. It must not fall down or break.
• If the batteries are flat, the corresponding symbol lights up. In that case, please
replace all three batteries.
GB
77