Switching Off; Remote Control - SOLIS TRIPLE FAN PLUS Bedienungsanleitung

3. Sleep mode: The
in an 80-second-long cycle in accordance with a pre-programmed run of alternating sequences of
various durations in the high – medium – low areas. This cycle is repeated for 30 minutes.
After 30 minutes, the unit changes to a different cycle lasting 80 seconds, where the motor spin in
accordance with an alternating pre-programmed pattern of sequences of various durations in the
medium – low – off areas. This cycle is also repeated for 30 minutes.
After another 30 minutes, the unit changes to another different cycle, also lasting 80 seconds, in
which the motor spins in accordance with an alternating pre-programmed pattern of sequences of
various durations in the medium medium/low – off/low – off areas. This operating mode continues
until you switch the fan off or select a different function.
Rotating movement
SWING: Touch the
The corresponding symbol will light up or go out, depending on the operating mode
Timer
TIMER: Touch the
 2,0 h......7,5 h  Off. You can set any time interval between 0,5 and 7,5 hours in 0,5-hour steps. The
time interval is shown by light symbols. Once the timer has been set, the remaining operating time will be
shown on the display (for example: if the timer is set to 2 hours, the display will show the time as 1,5 hours
once 30 minutes have passed). Once the set time has passed, the display goes out and the unit changes
over to Standby mode.
Shift
SHIFT: Press the
as required:
1. If you press the
"Fan 3" symbols will flash for 5 seconds.
2. Press the ,
3 on or off individually. If two fan blades have already been switched off and you want to stop the last
fan too, pressing the above button will have the same effect as pressing the
3. If you press the
at all for 5 seconds, the unit will exit this operating mode and the affected symbols will no longer flash.

Switching off

OFF: Touch the
Standby mode.

Remote control

All of the functions of the machine can also be activated using the remote control device. The functions
of the buttons on the remote control are the same as the buttons on the control panel. Point the remote
control at the front of the control panel to activate the functions. If anything stands in the path of the
infrared beam, the remote control will not work. Please store the remote control carefully in a safe place.
Do not allow it to fall to the floor. There is a bracket on the back of the casing for convenient storage of
the remote control.
970-89_TripleFanPlus-Betriebsanleitung_ger-fra-eng-ned.indd 17
symbol lights up, while the
button during normal operation to switch the rotating movement on or off.
button during normal operation to set the time to 0,5 h  1,0 h  1,5 h
button when the machine is switched on to activate any particular fan blade,
button once, thus activating the setting phase, the "Fan 1", "Fan 2" and
, buttons during this adjustment phase to switch Fans 1, 2, or
or , buttons during the setting phase, or do not press any buttons
switch to turn off all the functions and displays. The unit will switch over to the
symbol stays off. The motor spins
.
button.
17
30.10.14 11:37