Radio Reception - Sony MEX-GS820BT Bedienungsanleitung

Stored stations and correct time are
erased.
The fuse has blown.
Makes a noise when the position of the
ignition is switched.
 The leads are not matched correctly with
the car's accessory power connector.
During playback or reception, the
demonstration mode starts.
 If no operation is performed for 5 minutes
with [DEMO-ON] set, the demonstration
mode starts.
– Set [DEMO-OFF] (page 20).
The display disappears from/does not
appear in the display window.
 The dimmer is set to [DIM-ON] (page 23).
 The display disappears if you press and
hold OFF.
– Press OFF on the unit until the display
appears.
 The connectors are dirty (page 26).
The display/illumination flashes.
 The power supply is not sufficient.
– Check that the car battery supplies
enough power to the unit. (The power
requirement is 12 V DC.)
The operation buttons do not function.
The disc will not eject.
 The connection is not correct.
– Check the connection of the unit.
If the situation does not improve, press
the reset button (page 8). The contents
stored in memory are erased.
For your safety, do not reset the unit
while you are driving.

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not
extend, check the connection of the
power antenna (aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
65 MHz to 74 MHz in FM3 cannot be tuned
in.
 [AREA] is set to [EUROPE].
– Set [AREA] to [RUSSIA] (page 20).
RDS
RDS services cannot be received (when
[AREA] is set to [RUSSIA]).
 FM3 is selected.
– Select FM1 or FM2.
 RDS services are unavailable in the current
region.
The SEEK starts after a few seconds of
listening.
 The station is non-TP or has weak signal.
– Deactivate TA (page 12).
No traffic announcements.
 Activate TA (page 12).
 The station does not broadcast any traffic
announcements despite being TP.
– Tune in another station.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program
type.
Program service name flashes.
 There is no alternative frequency for the
current station.
– Press / (SEEK –/+) while the
program service name is flashing. [PI
SEEK] appears and the unit starts
searching for another frequency with
the same PI (program identification)
data.
CD playback
The disc does not play.
 Defective or dirty disc.
 The CD-R/CD-RW is not for audio use
(page 25).
MP3/WMA/AAC files cannot be played.
 The disc is incompatible with the MP3/
WMA/AAC format and version. For details
on playable discs and formats, visit the
support site on the back cover.
29
GB