Voltage Selection - Laney R500 Bedienungsanleitung

REAR PANEL CONTROLS
Panel layout and control functions for R500H and R500- 115are the same, so only one model has been shown.
POWER
suppu VOLTAGE
FUSERATING
1
Mains POWER Switch.
2
Power INLET SOCKET - Connect to your power source.Make sure the specifiedvoltage is correct for your country!
Tip: Themain safetyfusefor the unitis insidethisdrawer.
USE ONLY THE CORRECT

VOLTAGE SELECTION

3
can be reset by removing the mainsleadand then loosening(but not removing) the screws securingthe cover. The cover canthen be
pivoted awayfrom the switch which can be moved to select the alternate voltage. DO NOT reconnect the mains leaduntil the cover is
replacedand secured. Pleaseensure the correct fuse is fitted (asprinted on the panel)for the voltage being used.
Information area relatingto the amplifier:SerialNumber, FuseTypeand Ratingetc.
4
@ LOUDSPEAKE R -This NL4 socket isused t oconnect an extension-cabinet.
R500H - SPEAKER IMPEDANCE
R500-1 15 - SPEAKERIMPEDANCE MUST NOT BE LESS THAN 80HMS (due to onboard speaker which is always connected).
Impedances greater than those stated above won't damage the amplifier, but will result in a reduced output level.
Connecting cabinets that have a lower impedance than 4 Ohms will result in the amplifier overheating. Continual use in this
manner may cause permanent damage.
uxmm POWER cDNWPT10N
Laney
MODEL BASS GUITAR AMPLIFIER
00 NOT OBSTRUCT
DESIGNED IN THE BY LANEY
SIZEAND RATING OF FUSE AS SPECIFIED
Switch - This is factory set to the correct voltage for the region the product is suppliedto. If necessaryit
MUST NOT BE LESS THAN
www.Laney.co.uk
TOTAL MIN
VEM APERTURES
REFER TO
ON THE PANEL
4 OHMS.
4
CLASS
LOUDSPEAKER
FSI
np EQ OWOFF
TUNER OUT
FX SEND