Faz 3000-Tf Technical Data - elv FAZ 3000-TF Bedienungsanleitung

· Go to the base station, which displays the following:
Contact
_
· Use the keyboard to enter the name of the sensor:
· Several letters are printed on the keys. The letters are accessed by pressing the
key several times.
· Two seconds after the last key press the cursor jumps to the next figure.
· Use "Menu a/A" to switch between upper and lower case.
· Press "0∪" for a space.
· Press "←C" to delete a letter entered by mistake.
· Press "OK" to finish entering a name, the following appears on the display:
Clos.:
intern:
· Use the "→" key to set: Internal sensor Y/N (yes/no).
· Use the "↑" key to set the closure group.
Clos.:
intern:
· Use the "→" key to set: Closure group Y/N (yes/no).
· Press the "OK" key to register the next sensor. The base station displays the fol-
lowing:
Sensor X
free
· Additional door/window transmitters are registered as described previously.
· When all sensors are registered, the procedure is terminated by pressing the "←C"
key three times.

5. FAZ 3000-TF technical data

Batteries:2 x Micro AAA (+ 1 x Micro AAA and 3 x LR44 with additional glass break-
age transmitter)
Additional magnet sensors: ..................................................... normally closed (NC)
Additional glass breakage transmitters: .................................... normally open (NO)
Frequency: ............................................................................................ 868.35 MHz
Range: ................................................................................. up to 500 m (free field)
Dimensions (W x H x D) ............................................................... 53 x 163 x 24 mm
Note: After changing the batteries internal contacts must be opened and closed so
that they become active.
X
N
N
N
N
15