Einstellen Der Taumelscheibe - Walkera HM 5#4B Bedienungsanleitung

1. Inspektion der Taumelscheibe. (Bild 4) Um die Position
der Taumelscheibe zu überprüfen, ziehen sie den Gashe-
bel sowie dessen Trimmung ganz zurück und schalten Sie
anschliessend Sender und Helikopter an. Stellen Sie nun
sicher, dass der Knüppel für Roll und Nick und dessen
Trimmungen auf neutral stehen und überprüfen sie nun,
ob die Taumelscheibe horizontal ist.
2. Einstellen der Taumelscheibe. Sollte die Taumelscheibe
nicht horizontal sein, so stellen Sie diese folgendermas-
sen ein:
a) Stellen Sie sicher dass der Winkel zwischen Servohebel
und Anlenkung 90˚Grad beträgt.
b) Stellen Sie die Länge dieser Anlenkung so ein, dass die
Taumelscheibe horizontal ist.
The HM 5#4B is a preassembled model helicopter. The product has been inspected thoroughly before
leaving the factory. But checks and adjustments are necessary before every operation, to enjoy unspoiled
flight.
Check that the mounting screws for the main rotor blades are not too tight, as they blades may not be able
to swing into opposite position to each other, which would result in dangerous vibrations. When replacing
main blades, do this always in a pair and do not mix blades from different blade sets.
Take the transmitter battery holder out of its compartment in the back of the transmitter. Insert the required
(not included) 8 AA batteries. Be aware that the holder takes 4 batteries in the front and 4 in the back. You
are legally responsible to properly discarding used batteries. Please contact your local authorities.
Place the included Lithium-Polymer flight battery on a non-flammable surface and charge it with the inclu-
ded special charger for about 2 hours before your first flight. Do not overcharge the battery. Future charge
times may be shorter due to the fact that the battery may still hold a partial charge. If it is getting more than
hand warm, disconnect the battery from the charger. Never charge the battery unattended. Never use a
charger, which is not explicitly designed to charge this type of Li-Po batteries! Otherwise you may destroy
the battery or it may even explode or cause fire.
Land the helicopter as soon as you experience a power loss (helicopter gets sluggish). Take the bat-
tery out of the battery holder in the helicopter and let it cool down on a non-flammable surface before
recharging. It is always a good idea, to have a second battery available to continue flying, while the first

Einstellen der Taumelscheibe

Before Your First Flight
Bild 4:
Anlenkung
26
Taumelscheibe
Servohebel