Interrupting operation
Release the lever of the trigger gun; the
device will switch off.
Note:
When switching off the appliance, the water
pressure is reduced by approx. 70%. This
reduces the actuating force of the hand
spray gun and the service life of the appli-
ance is increased.
Release again the lever of the trigger
gun; the device will switch on again.
Turn off the appliance
Set the appliance switch to "0".
Disconnect the mains plug from the
socket.
Shut off water supply.
Activate trigger gun until device is pres-
sure-less.
Press the safety lever of the trigger gun
to secure the lever of the pistol against
being released accidentally.
Storing the Appliance
Place the spray lance with the trigger
gun into the quiver for the spray lance
and snap it into place in the spray lance
holder.
Wind the connection cable around the
cable holder.
Coil up the high pressure hose, hang it
over the hose rack and secure it by
means of the rubber band.
or
Coil up the high-pressure hose on the
hose drum. Fold down the handle of the
crank.
Fasten the plug with the mounted clip.
Press the unlocking device of the push
handle and slide the push handle in.
Frost protection
ATTENTION
Frost will destroy the not completely water
drained device.
Store the appliance in a frost free area.
If you cannot store it in a frost-free place:
Drain water.
Pump in conventional frost protection
agents through the appliance.
22
Note:
Use normal glycol-based anti-freezing
agents for automobiles.
Observe handling instructions of the anti-
freeze agent manufacturer.
Operate device for max. 1 minute until
the pump and conduits are empty.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
In order to transport the appliance over
longer distances, pull it behind you
holding on to the push handle.
In order to carry the appliance, hold on
to the handles.
In order to climb stairs, pull the appli-
ance up step by step. The skids protect
the casing from damage.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Transport bracket for surface
Attach the connecting piece of the sur-
face cleaner to the bolt at the high-pres-
sure cleaner.
Screw on the union nut by approx. 1 ro-
tation.
Transport by crane
Attach the lifting device to the carrying
handle of the appliance.
– 5
EN
Transport
cleaner