Herunterladen Inhalt Inhalt Diese Seite drucken

Vorwort/Anschlussmaße; Preface/Connection Dimensions; Introduzione/Quote Di Collegamento - PHARO Aquafun 95 Shower Montageanleitung

Inhaltsverzeichnis

Werbung

Vorwort/Anschlussmaße

Preface/Connection Dimensions

Introduzione/quote di collegamento

Deutsch
Die Montageanleitung enthält die wichtigsten
Montageschritte und Installationshinweise für
die auf der Titelseite bezeichneten Produkte.
Lesen Sie die Montageanleitung aufmerksam,
um Montagefehler zu vermeiden. Die Dampf-
dusche wurde nach den geltenden Richtlinien
hergestellt. Unsachgemäße Montage kann zu
Verletzungen führen!
Information
Die Dampfdusche wurde konform mit den
Niederspannungsrichtlinien
93/68 EWG und der Norm CEI 64-8 (IEC
364) hergestellt. Die Schutzart der Dampfdu-
sche ist IPX4, die Nennspannung ist 230 V,
die Nennleistung ist 2400 W für die Ausfüh-
rung Steam und Deluxe.
Die von der "Europarichtlinie" für elektroma-
gnetische Verträglichkeit auferlegten Sicher-
heitsanforderungen
(Richtlinie
EWG, 92/31/EWG, 93/68/EWG) und die
Konformität wird durch die Anwendung fol-
gender europäischer Normen gewährleistet;
EN 55014, EN 55104, EN 61000-3-2 und
EN 61000-3-3.
Anschlussmaße
(Abb. B)
Position 1: Empfohlene Stelle für den
Austritt der elektrischen Versorgung aus der
Wand (Kabel 3 x 1,5 mm
2600 mm).
Position 2: Empfohlene Stelle für
den Kaltwasseranschluss DN 15 1/2"
Innengewinde für die Verbindung zum
Thermostat.
Position 3: Empfohlene Stelle für den
Warmwasseranschluss DN 15 1/2" Innenge-
winde für die Verbindung zum Thermostat.
Position 4: Empfohlener Bereich für den
Wasserablauf DN 50.
Hinweis:
Mindestraumhöhe von 2300 mm notwendig!
Einbau in fertig gefliestes Bad mit
"Fliesenspiegel" auf mindestens 2200
mm!
Erdungskabel: Querschnitt von mindestens
4 mm
2
und einer Länge von ca. 2600 mm!
4
These installation instructions contain the most
important installing procedures and installati-
on notes for the products stated on the front
page. Please read these instructions carefully
in order to avoid incorrect installation. The
steam shower has been manufactured in
accordance with the applicable regulations.
Any improper installation may lead to inju-
ries!
Information
73/23/EWG,
The steam shower has been manufactured in
compliance with the 73/23/EEC Low-Voltage
Electrical Equipment Directive, 93/68 EEC
Low-Voltage Electrical Equipment Directive
and the CEI 64-8 (IEC 364) standard. The
steam shower's degree of protection is IPX4,
its rated voltage is 230 V, its rated output for
the Steam and Deluxe versions is 2400 W.
89/336/
The compliance with the safety requirements
(89/336/EEC,
guidelines) specified by the "European Gui-
deline" for electro-magnetic compatibility is
assured by the application of the following
European standards; EN 55014, EN 55104,
EN 61000-3-2 and EN 61000-3-3.
Connection dimensions
(Fig. B)
Position 1: Recommended position for elec-
2
/ Kabellänge
trical supply cable exit from the wall (cable 3
x 1.5 mm
2
Position 2: Recommended position
for cold water connection DN 15 1/2"
internal thread for connection to the
thermostat.
Position 3: Recommended position for
warm water connection DN 15 1/2" internal
thread for connection to the thermostat.
Position 4: Recommended area for water
drainage DN 50.
Note:
A minimum room height of 2300 mm is
required! Installation into completely
tiled bathroom with a minimum "tiled
area" of 2200 mm!
Earthing cable: Cross section of at least
4 mm
2
and a length of approx. 2600 mm!
English
92/31/EEC,
93/68/EEC
/ cable length 2600 mm).
Italiano
Le istruzioni di montaggio descrivono le
più importanti operazioni di montaggio e
le avvertenze di installazione per i prodotti
indicati nella pagina di copertina. Leggere
attentamente le istruzioni di montaggio per
evitare errori. La doccia a vapore è stata rea-
lizzata conformemente alle direttive vigenti. Il
montaggio scorretto può provocare lesioni!
Informazione
La doccia a vapore è stata realizzata confor-
memente alla direttiva sulla bassa tensione
73/23/CEE, 93/68 CEE ed alla norma CEI
64-8 (IEC 364). La classe di protezione della
doccia a vapore è IPX4, la tensione nominale
di 230 V e la potenza nominale di 2400 W
per i modelli Steam e Deluxe.
I requisiti di sicurezza previsti dalla direttiva
europea sulla compatibilità elettromagnetica
(direttiva 89/336/CEE, 92/31/CEE, 93/
68/CEE) e la conformità vengono garantiti
dall'applicazione delle seguenti norme euro-
pee: EN 55014, EN 55104, EN 61000-3-2
e EN 61000-3-3.
Quote di collegamento
(fig. B)
Posizione 1: punto consigliato per la fuo-
riuscita del cavo di alimentazione elettrica
dalla parete (cavo 3 x 1,5 mm 2 / lunghezza
2600 mm).
Posizione 2: punto consigliato per il raccor-
do dell'acqua fredda DN 15 1/2" con filetta-
tura interna per il collegamento al termostato.
Posizione 3: punto consigliato per il raccor-
do dell'acqua calda DN 15 1/2" con filetta-
tura interna per il collegamento al termostato.
Posizione
4: zona consigliata per lo
scarico dell'acqua DN 50.
Avvertenza:
Altezza minima del locale 2300 mm! Mon-
taggio in stanza da bagno piastrellata
con altezza minima della piastrellatu-
ra di 2200 mm!
Cavo di terra: sezione minima 4 mm 2 e lun-
ghezza di circa 2600 mm!

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis