Installation Procedures - Vevor Rc-1803J Bedienungsanleitung

5
Take parts G, H, Lx2, Nx2, Px2, Rx2, and Sx4 and assemble them on the
component in step 4, as shown in the figure. Do not tighten the knob L to ensure
that the G/H component can move up and down on the vertical pipe to adjust its
position.

2. Installation Procedures

6
Insert the parts of AA laterally into the product in step 5, as shown in the figure,
and install them onto the fixing bracket at the rear of the car. Tighten the T, U, and
V parts and ensure that the T bolt parts are tightened using a wrench tool.
- 11 -