Batteries And Charging; Required Equipment - Losi Ten LOSB0126 Handbuch

EN

Batteries and Charging:

The TEN-T uses rechargeable batteries such as NiMH or LiPo.
These batteries all have special requirements to preserve
performance and last a long time. Read all instructions and
precautions that are provided with the batteries intended to be
used in the TEN-T.
• Read all instructions provided by the manufacturer
of the batteries.
• Responsible adult supervision is necessary while
charging batteries.
• Always check to ensure the polarity of battery connection
is correct.
• Never leave batteries unattended while charging.
• Never charge a battery while it is installed in the TEN-T.
• Do not charge any battery that appears to have
any damage.
• If there are exposed wires do not charge or use the battery
until you have installed shrink-wrap or replaced the
complete wire.
If charging NiMH batteries, select a charger to meet your
requirements. Chargers can be of two primary types for
their source of power: a 100-240V wall charger, or one which
requires a 12V power supply. Follow the charger manufacturer's
instructions and precautions during each use.
Supplied and Required Equipment
Supplied tools:
Glow Plug/Wheel Wrench
Four (4) Hex "L" Wrench Set
.050-inch, 1/16-inch, 5/64-inch, and 3/32-inch
Shock Bottom wrench
Turnbuckle/Shock Top wrench
Tools You Will Find Handy
In addition to the tools included with the TEN-T, you will find
the following both useful and in some cases necessary.
• Small flat blade and Phillips screwdrivers
• Needle-nose pliers
• Quality .050-inch, 1/16-inch, 5/64-inch, 3/32-inch, 1.5mm
and 2.5mm hex (Allen) drivers

Required Equipment:

Fuel – Preferably Nitrotane 20% Sport (LOSF0020). Note: This
fuel supports the engine warranty.
Fuel Bottle – The Losi 500cc fuel bottle (LOSB5201) is suggested.
4