Caretero RIO Bedienungsanleitung Seite 17

3 INSTALLATION THE CAR SEAT REARWARD FACING (40-87 CM)
WARNING! If your car does not have an i-Size seating position, contact the vehicle manufacturer.
WARNING! The newborn insert is used to protect the child. Must be used up to 60 cm tall child.
Press the button on the side of the seat base and turn the seat backwards (3.1). Pull the lever under the seat
and adjust the seat to the highest angle (3.2). Locate the seat equipped with Isofix anchors in the car. If the
ISOFIX hooks are difficult to access, install the additional connectors
buttons on the sides of the ISOFIX hooks to slide them out (3.4). Place the car seat on the seat in your car
rearward facing. Align the base ISOFIX hooks with the ISOFIX anchors in the car. Insert the hooks into the
ISOFIX anchors in the car, push the child seat until they click into place (3.5). Make sure the markers on the
ISOFIX hooks change from red to green (3.6). Make sure the seat stays securely in place.
Make sure the support leg is facing forward. Press the release button of the leg lock and pull it out until it rests
securely on the car floor (3.7). Make sure that the seat leg indicator on the base shows green (3.8).
Make sure that support leg must never be suspended in mid-air or supported by other objects.
Make sure that the support leg does not lift the bottom of the base of the child seat up from the surface of the
vehicle seat.
WARNING! The leg supporting the car seat must always rest on the floor of the car. Do not place any objects
under the seat leg.
To disassemble the car seat, press the leg lock release button (3.9) and fold the leg towards the car seat
(3.10). Then release the ISOFIX hooks by pressing the buttons in the guides on both sides of the seat and
pulling the seat towards you (3.11).
4 INSTALLATION THE CAR SEAT FORWARD FACING (76-105 CM)
WARNING! A child can be carried in a forward-facing seat only when they are 15 months old and at the
same time reach 76 cm tall!
WARNING! If your car does not have an i-size seating position, or if you are in doubt as to whether you can
mount a car seat in your car, contact the vehicle manufacturer.
Press the button on the front of the child base and turn the child seat in a forward-facing direction (4.1).
Locate the seat equipped with Isofix anchors in the car. If the ISOFIX hooks are difficult to access, install the
additional connectors included in the set (4.2). Press the buttons on the sides of the ISOFIX hooks to slide
them out (4.3). Place the car seat in the forward-facing direction in your car. Align the base ISOFIX hooks with
the ISOFIX anchors in the car (4.4). Insert the hooks into the ISOFIX anchors in the car, push the car seat
down until the catches click into place (4.5). Make sure the markers on the ISOFIX guides change from red to
green (4.6).
Make sure the support leg is facing forward. Press the leg lock release button (4.7) and pull it out until it rests
securely on the car floor. Make sure that the seat leg indicator on the base shows green (4.8).
Move the child seat to check that it is properly fastened.
WARNING! The leg supporting the car seat must always rest on the floor of the car. Do not place any objects
under the seat leg.
To disassemble the car seat, press the leg lock release button (3.9) and fold the leg towards the child seat
(3.10). Then release the ISOFIX catches by pressing the buttons in the guides on both sides of the seat and
pulling the seat towards you (3.11)
included in the set (3.3). Press the
15