Gemü 3021 Original - Betriebs- Und Montageanleitung Seite 43

SetFunction
(Setting or resetting of
calibration values)
SetBatchQty
SetBatchFast
SetBatchNo 1-4
SetBatchQty1
SetBatchQty2
SetBatchQty3
SetBatchQty4
SetBatchFast1(-4)
SetQtyFactorTime
SetQtyOffset
GetBatchCycles
GetTotalBatchQty
Back to Menu
SetCalibration
(Setting of calibration values)
BatchOffset
K-Factor
ZeroOffset
Sensor Check
Back to Menu
Service
Version
Sensor Check
Service A
Status
Status
The settings can be changed according
to the following menu overview. The small
+ –
squares
Definition
Input of batch quantity
Input of percentage of batch quantity
which is to be filled fast
Input of batch process that is active
during manual operation
Input of batch quantity for Qty 1-4
Input of percentage of batch quantity
to be filled fast
Input of proportionality factor in the
selected measurement unit / second
Input of the quantity which is batched
independent of time in the selected
measurement unit
Total number of batch cycles, incl.
aborted cycles
Total batch quantity incl. aborted
cycles
Back to main menu
Definition
Input of value for plant-specific
adjustment
Input of pulses / litre
Offset conditioned by turbine -
start-up-value / zero point correction
Check of sensor
Back to main menu
Definition
Indication of software version
Check of sensor
Service number is displayed
Programming mode can be locked
Input of code number
represent the keys on
Values / Unit / Remark
1 L
0 %
1
1 L
2 L
3 L
4 L
0 %
0.1 L / s
0 L
0
0
Values / Unit / Remark
0.000
Set at the factory, see test certificate
Set at the factory, see test certificate
Carried out at the factory
Values / Unit / Remark
Carried out at the factory
unlocked
Code: 0
the flow transmitter which must be pressed
to reach the next menu item or to reach the
different settings within the menu.
43 / 52
3021