Instructions Of Use - Skylotec Harness Gebrauchsanleitung

Instructions of Use

The harness at hand does not match ALL properties described
below. it functions as a body restraining device for a personal
fall protection system in accordance with EN 363.
EN
1.) Use of eyelets
2.) Eyelets and standards
2.1) Extended rear eyelet (suitable for fall protection use)
3.) Fitting the harness
3.1) Checking harness for damage. Check in particular buck-
les and webbing for wear / cracks. if there are any doubts
about the safety condition, revoke its use immediately.
3.2) Fit harness according to type
Jacket construction: A: fit harness; B: lock leg loops; C:
lock pelvic strap; d: according to type, either feed webbing
through chest eyelet and simply lock in chest area, or join
loops with a carabiner; E: back eyelet must be seated cen-
trally between shoulders.
V construction: step in leg loops, pull V construction over the
head and lock carabiner in pelvic area with eyelet.
Hip belt construction: step in leg loops, lock leg loops.
3.3) Harness control: adjust harness until it sits firmly, but
comfortably. Two fingers should fit between body and web-
bing.
4.) Features
4.1) partially elastic webbing for maximum agility
4.2) Flame retardant: tested according to EN iSO 15025-A
4.3) Fall indicator: triggered = fall took place, discard strap
4.4) Seawater-resistant
4.5) Tested in accordance with EN 361. To be used exclusively
with a fall arrester fitted to a rigid guide.
4.6) Safety knife
4.7) Eyelets for attaching the seat part (not used for fall pro-
tection)
4.8) Exchangeable rope clamp -> see separate manual
Rope clamps to be changed by trained, competent persons
only.
5). declaration of Conformity
6.) identification and warranty certificate
7.) Check card:
Entry of the annual audit
7.0 -7.3): To be completed at revision
7.0: Next check;
7.1: inspector;
7.2: Reason;
7.3: Remark
8.) individual data
individual data on purchased harness
8.1 -8.4: To be completed by purchaser
8.1: date of purchase;
8.2: date of first use;
8.3: User;
8.4: Company
7
MAT-BA-0139_Rescuepro_20130820.indd 7 21.08.2013 09:26:29