Pkm 9080 Bedienungsanleitung Seite 39

5. Pull the illuminant carefully out of the hole and
disconnect the energy supply wire.
6. Now connect the new illuminant to the energy
supply wire.
7. Push the wires back into the hole and fix the new
illuminant.
We expressly note that the illuminants as well as all kinds of filters
DANGER!
POSSIBLE CAUSE
The appliance does not work at all. LED does not work
The plug of the appliance is not
connected to the socket.
The plug has become loose.
The socket is not supplied with
energy.
The fuse is switched off.
Ventilation damper blocked.
Condenser defective.
Motor mounting defective.
Motor defective
One-way valve has a leak
do not carry a guarantee!
Replacing of the power cord
The power cord must be replaced by a qualified
and authorized professional only.
7. TROUBLE SHOOTING
MALFUNCTION
Light is on but motor does not work.
Abnormal motor-smells.
Smear of oil.
MEASURE
Check the corresponding socket by
connecting it with another appliance.
Check the fuse.
The voltage is too low. Compare the
data on the model plate with the data
of your energy supplier.
remove blockage.
replace condenser.
replace motor.
replace motor
seal the valve
39