Intended Use - Becker Centronicplus Sc861 Plus Montage- Und Betriebsanleitung

The sensor described in these instructions must only be used for CentronicPlus-com-
patible radio drives and radio control units.
The sensor is only intended for operating sun protection systems that are not used as
privacy systems at the same time.
Use for any other purposes or for purposes beyond the above constitutes improper
use.
• Please note that radio-controlled systems may not be used in areas with a high risk
of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and systems in which
malfunctions in the transmitter or receiver would not pose any risk to persons, an-
imals or property, or which contain safety devices to eliminate such risks.
• The operator is not protected from interference from other telecommunications
systems and terminal equipment (e.g. even from radio-controlled systems which
are properly operated in the same frequency range).
• Only connect radio receivers to devices and systems approved by the manufac-
turer.
• Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
• Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

19 - en