Troubleshooting - Sony Walkman MZ-E310 Bedienungsanleitung

Troubleshooting

Should any problem persist after you have made these checks, consult your nearest Sony
dealer.
Symptom
The player does not
work or works
poorly.
The MD does not
play normally.
The MD does not
play from the first
track.
Cause/Solution
• You tried to operate the player with no MD in it. ("NoDISC"
flashes in the display.)
, Insert an MD.
• The HOLD function is turned on ("HOLD" appears in the
display when you press an operation button on the player).
, Disable HOLD by sliding the HOLD switch to the opposite
direction of the arrow (pages 7, 18).
• Moisture has condensed inside the player.
, Take the MD out and leave the player in a warm place for
several hours until the moisture evaporates.
• The dry battery is weak ("LoBATT" flashes or nothing appears).
, Replace the dry battery with the new one (page 6).
• The dry battery has been inserted incorrectly.
, Insert the battery correctly (page 6).
• An MD with nothing recording on it is inserted. ("BLANK"
flashes in the display.)
, Insert a recorded MD.
• The player cannot read the disc. (It's scratched or
dirty.)("ERROR" flashes in the display.)
, Reinsert or replace the disc.
• While operating, the player received a mechanical shock, too
much static, etc.
, Restart the operation as follows:
1 Remove the dry battery.
2 Leave the player for about 30 seconds.
3 Reinsert the dry battery.
• The player is set to repeat mode. ("
player.)
, Select "Normal" for the play mode and start playback. For
more details, "Selecting the play mode" (page 10).
• The disc is playing in group mode.
, Turn off group mode.
• The disc stopped playing before reaching the last track.
, Hold down
N>
from the first track.
• The disc is playing in group mode.
, Turn off group mode and stop playback. Then hold down
for 2 seconds or more to start playing from the first
N>
track.
" is displayed on the
for 2 seconds or more to start playing
21
-GB