Parts List; Installation Guide - Create Microwave Studio Bedienungsanleitung

1. Grill
2. Door
3. Door security locking system
4. Glass tray
5. Rotating ring
• Remove all packaging. Make sure to remove all packaging materials from inside the door.
Warning: Check the microwave for damage, such as a misaligned or bent door, damaged
door seals and sealing surface, broken or loose door hinges and latches, and dents inside the
cavity or on the door. If there is any damage, do not use the microwave and contact qualified
service personnel.
• This microwave should be placed on a flat, stable surface to support its weight and the
heavier foods that may be cooked in the oven.
• Do not place the microwave where heat or moisture is generated, or near combustible
materials.
• For proper operation, the microwave must have sufficient airflow. Allow a minimum of 20
cm of necessary clearance above the top and rear surface of the microwave and 5 cm on
both sides. Do not cover or block any openings on the appliance. Do not remove the legs.
• Do not use the microwave without the glass plate, support and shaft in their correct
positions.
• Make sure the power cord is not damaged and does not run under the microwave or over
any hot or sharp surfaces.
• The plug should be easily accessible so that it can be easily unplugged in an emergency.
• Do not use the microwave outdoors.

PARTS LIST

6. Axis
7. control Panel
8. Waveguide (do not remove the mica
plate covering the waveguide)
9. Metal grill rack

INSTALLATION GUIDE

E NGLI SH
9