Using Tips - Retevis Rb629 Bedienungsanleitung

Warning
Please read this manual carefully before using this radio.
• Please do not communicate or charge this radio in flammable, explosive and area which radio
communication is prohibited (such as oil station, gas station, airport etc.)
• Please do not operate this radio without license in govemment laws banned areas
• Please make sure this radio avoids the sunshine, and avoids to put it near any heating device.
• Please make sure this radio avoids any dusty, humid and water splashed place, and also
avoids to put it near any heating device.
• If radio smells or smokes, please remove the battery pack from radio at once, and then please
contact your nearest distributor.
• The repair job of this radio is in the charge of professionals & technical's, self-disassembly is
prohibited.

Using tips

Unpacking and Checking the Equipment
·Carefully unpack the radio.We recommend that you confirm the items in the following table
before discarding the packing material. If any item is missing or has been damaged during
shipment, please contact your first seller.
Accessories list
Item name Quantity
Battery 2
Belt Clip
2
Hand strap
2
Charger
2
Screw 4
User's Manual 1
Using the battery
The battery is not completely charged at the factory, please charge it before using.
After purchase or extended storage (more than two months), the first time to charge battery
cannot make battery reach its normal operating capacity. After repeating charge /discharge it two
or three times, the operating capacity will increase to its normal capacity.
Notice: After fully charge the battery, please do not charge it again and should take it off from the
charger. If not, it will short or damage the battery life for over charge.
Installing / Removing the Battery
To install the battery into the battery positioning hole of radio bottom, then press the battery,
make the button completely to lock battery. To remove the battery, please turn off the radio, and
then push up the battery button of radio top, finally take off the battery.
(Install the battery)
01
(Remove the battery)
Installing Earphone /Programming Jack
Uncover earphone lid, directly insert earphones into earphone
holes (earphones need to be additionally purchased).
You can use computer programming software to operate (please
consult with local dealers about the information of computer
programming software).
Note: If your radio developed with VOX function, you should
re-turn on radio power once to active VOX function.
Installing the belt clip
If necessary, attach the belt clip to the back of battery
with the screws supplied carry conveniently.
Getting Acquainted
Antenna
LED indicator light
(The indicator light turns red
when transmit, turns green
when receive.)
Speaker
Microphone
Channel-selecting knob
Power/volume knob(Power on by
rotating clockwise,Power off by
rotating counter clockwise till
hear the "kata" sound.
VOL control by rotating.)
02