Samson ReTrack Schnellstartanleitung Seite 6

Setup
The Samson ReTrack is an ideal tool for reamping pre-recorded tracks in the studio. Here's how to set up
a typical reamp configuration using the ReTrack:
• Set all volume controls to minimum before making connections.
• Connect the output of your audio interface, mixer, or USB DAC to the COMBO INPUT.
Use the INPUT SELECT switch to choose the correct signal type (Line or Phones).
Connect the AMP OUTPUT to your amplifier or effect chain, and set the MUTE switch to NOT
•
MUTED.
Use the LEVEL TO AMP, volume rotary knob to adjust the output level to match your amp's input
•
sensitivity.
• If you hear a hum or ground noise, try flipping the GROUND LIFT switch.
• Adjust your amplifier and monitor settings as needed for your desired tone.