STOP&GO ROOFTOP Bedienungsanleitung Seite 31

status LED is lit. If the status LED does not light up after this time,
the marten repellent is faulty.
– The marten repellent is faulty. Disconnect the USB charging
cable immediately. Please contact customer service.
Problem: The remote control does not work.
– The remote control battery is empty. Replace the remote control
battery. To do this, use a slotted screwdriver to open the remote
control on the side with the loop opening. Use the slotted screw-
driver to pry the button cell out of the holder. Be careful not to
damage the remote control. Do not dispose of the battery in
household waste.
Problem: The marten repellent does not react when switched on.
– The battery of the marten repellent may be deeply discharged.
Charge the battery. After approx. 15 minutes, check whether the
status LED is lit. If the status LED does not light up after this time,
the marten repellent is faulty.
– The marten repellent is faulty. Disconnect the USB charging
cable immediately. Please contact customer service.
EN
31