Samsung SCC-B1311 Bedienungsanleitung Seite 16

6
F UNCTION SWITCH-2
If multiple cameras are connected to such as a
sequential switcher in auto switch mode, the camera
in the internal sync mode occurs a skip every time it
moves to other scene. However, this can be solved by
positioning the L/L switch to EXT and using the level bar
to adjust the vertical sync phasing.
- INT: It operates in the internal synchronization mode.
- EXT: it operates in the power synchronization mode.
※ If your camera uses DC 12V for power source,
it operates in the internal mode regardless of the
position (EXT/INT) of the L/L switch.
10
3D-B1311-EU.indb 10
7
D C IRIS Level Bar
Used to adjust the iris level of this level bar using a
screwdriver.
- Anti-clockwise: Decreases the luminance level.
- Clockwise: Increases the luminance level.
- The IRIS range of the DC lens is about between
80IRE and120IRE. In other words, the DC lens
adopts a variable range limitation system, rather
than IRIS Full Open/Close system.
- Depending on the type of the lens used that
allows setting the value below 75 IRE may cause
IRIS hunting. Therefore, make sure that the
range is set to an appropriate level (higher than
80 IRE).
8
V ideo Out Port
Connected to the Video Out port of a monitor.
The video signal is output via this port.
제 제 제 제 제 제 제 제 s p
SC
Ite
Pr
Br
Sy
Im
Nu
Pi
Sc
Li
Sy
Ho
Re
S/
M
Ill
AL
2008-04-30 오후