Install The Lensr; Adjust The Back Focus - Samsung SCC-B1311 Bedienungsanleitung

Install the lens
Loosen the single screw on the adjustable ring of the
flange back by turning it anti-clockwise and turn the
ring in the "C" direction (anti-clockwise) to the end.
Otherwise, it can cause damage to the internal image
sensor or the lens when you install the lens on the
camera.
Iris Control
Cable

Adjust the back focus

The back focus of a camera is predefined by the
factory default. However, some models are out of focus
depending on the lens type. If your camera is out of
focus, follow the instructions below to adjust the back
focus. The following is the procedure used to set the
proper back focus point in fixed focus lenses.
06
3D-B1311-EU.indb 6
Lens without zooming feature
1. Capture a sharp subject (with a grid pattern) more than
2. Adjust the adjustable ring of the flange back so that
3. Fasten the screw of the adjustable ring of the flange
Lens with zooming feature
C direction
1. Capture a sharp subject (with a grid pattern) 3-5m
2. Adjust the zoom in the WIDE direction as possible and
3. Repeat 1 and 2 above 2-3 times to match the focus
4. Fasten the screw of the adjustable ring of the flange
10m apart and adjust the focus ring to the infinity ( ∞ ).
you can capture the sharpest image.
back.
apart and adjust the zoom in the TELE (zooming)
direction as possible and also adjust the focus ring so
that you can capture the sharpest image.
turn the adjustable ring of the flange back so that you
can capture the sharpest image.
from the ZOOM TELE side with that from the ZOOM
WIDE side.
back.
- If you darken the image before
adjusting the focus by attaching
the ND filter to the front of the lens,
you can get a sharper focus.
Co
1. C
p
2. C
In
3. C
s
t
c
-
2008-04-30 오후