Sharp BK-ED06E Bedienungsanleitung Seite 27

__________________________________________________________________________________
Overcurrent In
"27"
the regulator.
Communication
" 30"
The brake signal
has a fault (if
"33" they are brake
mounted)
The sensing
circuit for 15V
"35"
it has a fault .
The detection
circuit on the
"36"
keyboard has a
The WDT circuit
"37"
is defective .
The tension
"41" total from the
Using the BESST tool , update The regulator . If the
problem persists , changes The regulator or contact
The your supplier .
1. Check that all the Pedelec connections they are
correctly executed .
2. Using the BESST tool , run a diagnostic test to try
to pinpoint the problem .
3. Change the view to see if the problem was solved
problem
4. Change the EB-BUS cable to see if the problem
solves .
5. Using the BESST tool, update the controller
software again . If the problem persists , change the
controller or contact your supplier .
1. Check that all the terminals they are connected to
the brakes correctly .
2. Change i brakes to see if the problem was solved
sensors
3. If the problem persists , change the regulator or
contact the supplier .
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite ,
change the regulator or contact yours supplier .
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite ,
change the regulator or contact yours supplier .
fault .
Using the BESST tool update the regulator
to see if the problem solves. Just in case opposite,
change the regulator or contact yours supplier .
Replace the battery.
drums
27