Sharp BK-ED06E Bedienungsanleitung Seite 26

__________________________________________________________________________________
sensor inside
the regulator .
Speed sensor
"21"
Torque signal
"25"
The torque
sensor speed
"26"
signal has a
2. If the problem persists , replace The regulator or
contact The your supplier .
1. Reboot your system
2. Check than the magnet attached to the spoke is
aligned with the speed sensor and that distance _ is
included between 10mm and 20mm.
3. Check than the speed sensor terminal is
connected correctly .
error
4. Connect the Pedelec to the BESST, to check for a
signal from the speed sensor .
5. Using the BESST tool , update the controller to see
if the problem solves .
6. Change the speed sensor to see if the problem
solves. If the problem persists, replace the regulator
or contact the supplier .
1. Check that all the connections they are correct -
mind executed .
2. Connect the Pedelec to the BESST system to see
if this can read the couple .
error
3. Using the BESST tool , update the reg-
olator to see if the problem is solved , if necessary
otherwise replace the torque sensor or contact your
supplier .
1. Check that all the connections are well executed
2. Connect the Pedelec to the BESST system to see
if this can read the speed sign .
3. Change the dial to fix the problem .
fault
4. Using the BESST tool , update the regulator to see
if the problem solves it , in case opposite replace the
torque sensor or contact yours supplier .
26