DUROFIX RC1222 Produktinformationen Seite 12

diam.)1.3"(Ø33mm) x (depth)0.5"(13mm) to make a tight fit.
WARNING!
wheel.
4. To remove, twist the dust extractor hose and remove. Replace the cap.
WARNING!
the operator.
VARIABLE SPEED SWITCH
Press trigger to start tool. Full press trigger and allow the tool to reach full speed before
beginning the cut. Release trigger to slow or stop the tool.
CONTROL SWITCH
The control switch can be set to two positions: rotate and lock. Loosen the trigger
before change the control switch. Set control switch to rotate position. The tool runs
clockwise when not installed dust shoe assembly. The tool runs counterclockwise when
installed dust shoe assembly automatically.
COOLING OF TOOL
Allow the tool to cool 15 min before continuous using.
If the cut off tool stalls or overheats, maintain a firm grip and release the trigger
immediately.
WARNING
Always wear proper safety equipment, including a dust mask. Protect everyone in the area from sparks.
Maintain a firm grip and correct body position to control the tool all time and prevent injure from kickback.
Always keep dust extractor hose out of the path of cut and away from the cut-off
Always replace the cap to avoid dust and debris from being directed up and toward
A
OPERATION
Make sure the tool fully stopped and trigger fully released before use control switch.
MAINTENANCE
1English1
B
Fig. 6
English -11