DUROFIX RC1222 Produktinformationen Seite 11

1English1
Fig. 4
INSTALLING REMOVING AND ADJUSTING THE DUST SHOE ASSEMBLY
WARNING
Always remove battery pack before changing or adjusting accessories.
The dust shoe assembly provides cutting stability, depth of cut control, and provisions
for dust extraction.
Loosen the depth of the cut wing nut (B) and fully draw apart the shoe (C). Press in the
shoe release button (A), put dust shoe assembly onto tool.
To adjust the depth of cut, loosen the depth of cut wing nut and slide the shoe up or
down. Use the markings on the depth of cut gauge to help determine proper depth.
Adjust the cutting depth to the thickness of the workpiece. Less than 1/4" of the wheel
should be visible below the workpiece
DUST COLLECTION
To use a dust extractor:
1. Install the dust shoe assembly.
2. Remove the cap (B) from the dust extraction attachment.
3. Twist the dust extractor hose (DEK26 or 1.25" diam.) into the opening (A) (inner
English -10