DUROFIX RZ1230 Produktinformationen Seite 12

• Inner seal in the caulk tube is broken
• Hardened material is removed from the nozzle
• Caulk tube is not damaged or frozen
• Rod is free of caulk/adhesive materials
STARTING AND STOPPING AND CONTROLLING SPEED
1. Pull trigger to dispense material.
2. Increase or decrease pressure on the trigger to dispense the material. Adjust the
speed dial to select the maximum speed for proper bead width and material flow
rate ("1" for slowest, "8" for fastest). The trigger pressure, selected speed,
material type, temperature and nozzle diameter will all affect the flow rate.
3. When using a tube or pack with a smaller nozzle diameter use a slower speed or
the material may be forced around the rear tube seat.
NOTE:
Operating the gun at high speeds may damage the dispensing tube or pack for some materials. For
best results, gradually increase speed settings.
4. Release trigger to stop dispensing material.
NOTE:
The piston will stop automatically when it has reached the end of the tube.
USING THE CONTROL LEVER
The Control Lever may be set to two positions: forward and rack release.
For forward, push in the Control Lever from the right side of the tool. The tool will
run normally.
To lock the trigger and release the rack, push in the Control Lever from the left side of
the tool. The rack can be moved to the desired position. The trigger will not work while
the Control Lever is in the locked position. Always lock the trigger or remove the
battery pack before performing maintenance, changing accessories, storing the tool and
any time the tool is not in use.
WARNING
Before checking or maintaining the tool, be sure to turn off the tool power switch and remove the battery
pack.
NOTE
This tool is lubricated before it leaves the factory. This lubrication should last for the life of
the tool. No further lubrication is required.
Do not use gasoline, benzene, thinner, alcohol or similar items to clean tools. Otherwise, the tool may
become discolored, deformed or cracked.
NOTE
In order to ensure the safety and reliability of the product, any repair or other maintenance
work must be carried out by the authorized or factory repair service center Be sure to use our company's
replacement parts.
1English1
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
English -11